Maintenance
How can you take care of your excavator as you would yourself in winter
1. If there is soil on the surface of the excavator, we must clean it thoroughly and check for any loose fasteners.
2. Check if the antifreeze level and engine oil level are normal, check if the engine oil quality is normal, and check the antifreeze level of the fuel.
3. If the weather is extremely cold and the excavator is out of service for a long time, please drain the coolant from the engine completely. At the same time, to prevent the battery from running out of power, it must be removed and stored in a warm place.
4. Start the engine and run it once at regular intervals. If the antifreeze level and engine oil level are lower than the normal level, please add them to the normal level in time before starting. When the weather is cold, place the key in the preheating position until the preheating light comes on (repeat the preheating multiple times), then start the engine and let it idle for 5 to 10 minutes. After that, operate each cylinder 5 to 10 times without load, each time 5 to 10 mm less than the maximum stroke. Finally, make the engine run at the maximum speed and quickly operate each cylinder 5 to 10 times. At the same time, operate the left and right rotation and the front and back movement 3 times each. The system can only be operated normally when the temperature rises to 50-80 degrees. Continue to operate all working devices for 5-10 minutes and then stop the engine.
5. The diesel should be replaced with -10 to -30 grades, which depends on the region. The further north the area is, the more -grade diesel should be added. Additionally, the diesel filter should be replaced. The engine oil should be replaced with the thickened oil suitable for the local area, and the oil filter should also be replaced. Any oil leakage in the hydraulic system should be replaced in a timely manner. If possible, the fuel tank should be well insulated.
6. The heat dissipation system should be carefully inspected for any aging or breakage of the rubber hoses. If any problems are found, they should be replaced in a timely manner as these areas are more prone to issues in winter. If hot water is available, it is best to heat the water in the radiator every day. This can help start the engine better, but be sure to remember not to forget to drain the water. The reason why antifreeze is not recommended is that it makes it more difficult to start the engine in extremely cold regions.
- Pre
How can tower crane rental enterprises master the maintenance technology, installation and maintenan
The installation support of the slewing bearing must have su...
- Next
Analysis of Maintenance and Care Methods for the Mechanical Parts of Cranes
1. Maintenance of motors and reducersRegularly check the tem...
Related articles
- How to troubleshoot the faults of the brake caliper of a loader
- Analyze the reasons why the excavator boom of CAT320B cannot descend
- How to install and adjust the speed control motor of the CAT325L excavator
- Empowering multiple fields, Sany diversifies to provide you with complete solutions
- Devanron: DX60 ACE: A tough young digger, truly deserving of his reputation
- Rejuvenating the city's Golden Corridor: BomAG contributes to the renovation project of Shenyang You
- This is the only one that gives you the "Soul Grasping Hand"! This time, you can finally g
- These two "treasure-level" wheel excavators will help you work on construction sites witho
- Why can over 90% of Yuchai firmly hold the top position in the power supply for wheel excavators?
- How to select the automatic leveling device for a paver